![]() ![]() Continue in this manner until the total station is set up at and having measured CP3Īs I mentioned earlier, the aim is to densify the control network by adding additional control points in each room.Move the total station to and measure multiple backsights to and CP2.Move the total station to and backsight to."Somehow" set up at the arbitrary location by backsighting to control point 1 (CP1).I'm imaging a sequence of steps as follows (also see sketch below): Now, however, I cannot set up the total station using the resection method because I cannot backsight to two or more control points. Prior to the erection of the internal walls, all three points were visible from a total station positioned in the middle of the building, which allowed for a resection setup to be done. None of the control points are visible from one another. I am tasked with densifying the control network by adding additional control points in each room. ![]() The control points are retro-reflective targets applied to structural steel columns. Each room has one first-order 3D control point-three in total. I have a building that is made up of three rooms (see sketch below). I'm using a Leica TS16 total station with Leica Captivate and MicroSurvey Star Net to adjust the field observations. I'm trying to figure out to how to densify a control network in the situation described below. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |